Honeywell Sensepoint XCD Technical Manual page 12

Sensepoint XCD Technical Manual
To mount the Sensepoint XCD transmitter to a Vertical or Horizontal pipe/structure, use
the optional XCD Mounting Kit and following procedure:
1. Fit the four spring washers, then the plain washers to the M8 x 80mm SS316 bolts.
2. Pass the four bolts through the four mounting holes of the transmitter housing.
3. Note: If the XCD sunshade is to be used then fit the sunshade and the two locking
bolts and washers to the M8 x 80 bolts.
4. Place the transmitter housing against the mounting position and fit the two "U"
channel mounting bars the other side of the Pipe/Structure.
5. Secure bolts to the threaded holes of the "U" channel mounting bars.
6. Tighten the four bolts securely, (but do not over-tighten) until the transmitter housing
cannot be moved by hand on its mounting position.
Note: For further details of installation please see section 17.
Diagram 5: Mounting arrangements
12
SPXCDHMANEN Issue 2