Honeywell Sensepoint XCD Technical Manual page 32

Sensepoint XCD Technical Manual
Sensor Cartridge
Weather Protection
To replace the plug-in sensor of a Sensepoint XCD Sensor Socket use the following
procedure:
1. Important: Remove the Power from the Sensepoint XCD Transmitter
2. Remove the Weather Protection or other accessories from the sensor socket
thread.
3. Loosen the Locking Grub Screw and unscrew the Sensor Retainer
4. Carefully pull the old Sensor from the sensor socket without twisting.
5. Fit the new Sensor in its place
6. Calibrate sensor
Ensure that the same Gas Type and Range of Sensor is fitted in place of the old Sensor.
Care should be taken when removing and refitting the Sensepoint XCD plug-in Sensor
Cartridge to the Sensor Socket so that damage to the connection pins can be avoided.
Sensor Socket
Sensor Retainer
Locking Grub Screw
Diagram 13: Sensor Replacement
WARNING
32
SPXCDHMANEN Issue 2