Honeywell Sensepoint XCD Technical Manual page 37

Sensepoint XCD Technical Manual
Relay Operation
Set Location
Set Temperature Unit
Check Alarm functions
Quit
Set Calibration
Select Sensor*
Select Gas*
Set Range
Configure
Inhibit
Set Password
Set Cal. Interval
Bump Test
* Note : "Select Sensor" and "Select Gas" menus are only available for flammable/IR sensors.
Table 7: Transmitter menu descriptions
Monitoring
Mode
Menu Switch
( > 3 Seconds)
No
Access permitted?
Inhibit mA O/P
Yes
Configuration Mode
(Inhibited)
Diagram 14: Configuration Mode
Configure relay on delay time, relay off delay
time and latch/non-latch
Set location (or TAG number)
Change temperature display unit.
°C (Celcius) or °F (Fahrenheit)
Simulate alarm situation to check the alarm
system without gas present at the sensor
Return to Monitoring mode
Quit/ESC command
Auto quit after no activity of timeout
Abort
Release mA O/P
37
SPXCDHMANEN Issue 2
Force Current
Set Alarms
Set Relays
Relay Operation
Set Location
Set Temperature
Unit
Test Alarms