Table of Contents
Advertisement
Placement
The detector can simply be placed on a flat surface or used with the optional cable
sensor to hang from a wall or be arranged on the ground. For wall mounting, use the
included screw and hang the detector on the mounting keyhole.
Optional cable sensor
To install the optional cable sensor, remove the sensor jack plug and insert
the cable sensor. Insert the sensor jack plug at the end the cable sensor.
Additional cable sensors (sold separately) can be connected to extend the
cable and increase water sensing area.
The entire length of cable is an extended sensor. You can hang the detector
from the wall or place both the detector and cable sensor on the floor.
Note: The cable sensor jack is NOT for plugging in a power adaptor. Plugging
in a power adaptor could damage the detector.
For help, go to getconnected.honeywell.com
If the detector is placed on the floor, be sure the
sensors have good contact with the floor. If you
expect a large flooding in the area where you
install your Lyric W1 water leak detector that
could submerge the unit, consider hanging it on
the wall (with provided screw and wall plug), and
using the included 1.2 m cable sensor for water
detection. To cover an even larger area, purchase
additional cable sensors to extend your coverage.
8
Advertisement
Table of Contents
