Installing Parallel Port Interface Kit (Ue-404070) - Panasonic DF-1100 Service Manual

Installing Parallel Port Interface Kit (UE-404070)

9.4
A. Contents
Qty.
1 Parallel Port Interface Assembly
1 Programmed ROM
1 Cable Harness
1 Printer Driver Diskette
B. Installation
Description
(1) Turn the Power Switch to the OFF (O) position.
(2) Disconnect the Power Cord.
(3) Disconnect the Telephone Line Cord.
(4) Remove the Memory Cover.
(5) Remove 5 Screws.
(6) Remove the Rear Cover.
(7) Break off the protective tab.
Note: Order a protective film (P/N: DZNE000019) to
cover up the opening if the interface is removed..
(8) Remove 1 Screw.
(9) Remove the Bracket.
(10) Install the Parallel Interface Assembly using the
screw that was previously removed.
(11) Connect the Option Harness to the CN16 as the
Core side of the harness is located on the FCB
PC Board.
(12) Replace the new Option ROM (IC50) on the FCB
PC Board.
(13) Re-install the Rear Cover.
(14) Re-install 5 Screws.
(15) Re-install the Memory Cover.
(16) Re-connect the Power Cord and the Telephone
Line Cord.
(17) Turn the Power Switch to the ON (I) position.
(18) Execute "PARAMETER INITIALIZE" in Test Mode
No. 6
Options and Supplies
Part No. Remarks
DZHP000415
DZAD000
DZFP000596
DZQW000004 Floppy Disk 2HD
9–5