Panasonic DF-1100 Service Manual page 158

Panasonic DF–1100
Code Mode
572 XMT
573 RCV
580 XMT
581 XMT
601 XMT
602 XMT
623 XMT
XMT or
630 RCV
(Polling)
631 XMT
634 XMT
638 XMT
Mem.XMT
870
Multi–copy
879 Mem.RCV
962
975 Initial test
Conf.XMT
Conf.Polling
995
Relay
Request
4–46
Information Codes
Phase Description of Problem
There was no response while machine
C transmitted the data during remote diagnostic
communication.
Unit could not receive the data from remote unit
C
during remote diagnostic communication.
Sub – address transmission to a unit that has
B
their DIS bit 49 (NSF bit 155) OFF.
Sub – address Password transmission to a unit
B
that has their DIS bit 50 (NSF bit 156) OFF.
ADF Door was opened during ADF
transmission.
Platen Cover was opened during ADF
Transmission.
No document was in the ADF. (Built–in dialer
A
engaged)
B
Redial count over.
"STOP" button was pressed during Auto
A
Dialing.
Redial count over with no response.
Note: Canadian models will not redial when
the communication fails due to no
response from the called station.
Power turned off with applicable data in
memory or during communication.
Memory overflow.
File register full.
Memory overflow during memory reception or
substitute reception.
Memory file access error.
Memory parity error.
Parameter setting for Relay Comm. or Conf.
Comm. is invalid.
Cause
Remote unit is defective.
Remote unit is defective.
Sub – address transmission to a unit that has
no Sub–address function.
Sub – address transmission to a unit that has
no Sub–address function.
Operator removed the document from the ADF
after dialing was completed.
Document is not set properly in the ADF.
No dial tone detected.
Sensor dial tone is not detected. (country
dependent)
Busy tone is detected. (country dependent)
T1 timer (35 5 sec) elapsed without a signal
from the receiver.
Power switched off.
Power failure occurred.
FCB PCB is defective.
Memory card was installed or removed when
data was in the DRAM on the FCB PCB or a
power failure has occurred while data was
stored in the memory.