Table of Contents
Advertisement
Setting a Wash Cycle
Select a washing cycle using the Cycle
Selector.
Select the wash water temperature
using Wash Temp.
Press available Option buttons. This is
optional.
Set the Dry Time knob to OFF.
Press Start. When the wash cycle ends,
the machine will stop.
Setting a Dry Cycle
Select the dry cycle by setting the
Cycle Selector to position 5, 10 or 13.
Select the length of drying time with
the Dry Time knob (20 to 180 minutes).
Press Start. When the dry cycle ends,
the machine will stop.
Laundry Tips:
Wash cycles are 35 to 100 minutes.
Dry times for average sized loads are
90 to 120 minutes.
Wash cycles use 7 to 18 gallons of
water. Some water may remain in
drum, this is normal.
Door automatically locks during the
wash and dry cycles.
9
DO NOT overload the drum. Use
small loads.
DO NOT exceed recommended
detergent or fabric softener amounts
Always use a fabric softener or
detergent with built-in softeners.
Only use Cotton Heavy Duty for heavy
031331b
cotton such as jeans and towels.
For items that may wrinkle use Low
Spin in wash and Synthetics Dry.
DO NOT over dry laundry.
Cleaning the Machine:
The exterior and rubber parts can be
cleaned with a soft cloth soaked in
lukewarm soapy water.
DO NOT use solvents or abrasives.
DO NOT use polish on plastic trim.
Cleaning the Dispenser Drawer:
Remove the dispenser by raising it and
pulling it out.
Wash it under running water.
Repeat as needed.
Caring for the Door and Drum:
When not in use, leave the door ajar to
prevent unpleasant odors from forming.
Turning Off Water or Electric Supply:
After every wash turn off water supply.
This will limit the wear on the water
system and also prevent leaks.
When cleaning, on vacation or during
maintenance operations, unplug the
appliance.
Maintenance:
Check water inlet hoses at least once a
year.
Clean filters and water valves
If any cracks, bulges or wear are seen,
replace hoses immediately.
CAUTION
DO NOT use inlet hoses that have been
already used.
INFORMATION
Replace the inlet hoses at least every
five years of use. When replacing
the inlet hoses, mark the date of
replacement on a label with a
permanent marker.
INFORMATION
Should the washer/dryer need removal
for service, care should be taken as the
appliance weighs approximately 150
lbs. Use proper accommodations to
avoid personal injury or damage to the
cabinetry.
Cleaning the Pump Pre-Chamber:
The washer/dryer is fitted with a self-
cleaning pump that does not require regular
maintenance. However, if small items such as
coins or buttons fall into the pre-chamber that
protects the pump, these items will need to be
removed.
Consult washer/dryer OEM manual on
how to access the pre-chamber.
Lint:
The unit removes lint automatically. There is
no lint filter to clean. It is recommended that
the outside vent and dryer ducting be inspected
to remove lint accumulation.
Advertisement
Chapters
Table of Contents
Troubleshooting
