Waste Pump (Optional) - Monaco 2009 Knight Owner's Manual

Open the solid waste drain (black)

valve. Allow the black tank to drain.
Connect one end of the pressure

regulator to the water source and
one end to a non-potable water hose.
Connect the non-potable hose to the
tank flush fitting.
Turn on the water source and allow

water to rinse the black tank at least
three minutes. DO NOT operate the
system unattended. Ensure the water
flows freely though the drain hose.
When completed, turn off the water

source and close the black water valve.
Open the grey water valve. The water

in the grey tank will flush remaining
solids from the hose. With the grey
water valve open, run two gallons of
water down any drain to flush grey
tank. The grey valve remains open
until the next drain cycle, or time of
departure.
WARNING
Operating the flush system unattended
can risk flooding. Use the tank flush
system each time the holding tanks
are cycled. Failure to routinely use the
flush system will result in a clogged
spray nozzle. Turn off the water supply
when finished flushing the tank.
When preparing for travel, close both

dump valves. Undo restraining devices
040460w
from the hose. Disconnect the hose
from the termination drain by rotating
the fitting counterclockwise 90º.
Raise the hose and drain using hand

over hand method working the hose
towards shore fitting. Rinse the hose
with outside facility and repeat the hose
drain process.
Remove the hose from shore fitting.

Install hose in carrier and lock door.
Secure the termination cap (required
by law in some states) to termination
drain.
If desired, add chemicals to the tanks

to control odor. Follow the directions
given by the manufacturer of the
chemical.
NOTE
Dump the black tank before driving.

WASTE pUMp (OpTIONAL)

The waste pump (Sani-Con system) is a self-
priming impeller pump designed to minimize
clogging when draining the tanks. The system
comes with a 1½" outlet hose with sewer pipe
adapter and a 13 gallon per minute macerator
pump.
When operating Sani-Con it is recommended
to wear disposable gloves, safety glasses
and protective clothing. The house battery
disconnect switch, located in curbside battery
compartment, must be on for the Sani-Con
system to operate. The waste pump operates on
12 Volts from the house battery.
INFORMATION
For additional information consult RV
Sani-Con literature or website:
www.emptythetanks.com
WARNING
DO NOT place in the toilet personal
hygiene products, cigarette butts,
paper towels, table scraps, grease, any
tissue that remains in one piece, any
object that can be considered foreign.
These objects will damage the Sani-
Con system and void manufacturer's
warranty.
WARNING
DO NOT leave the Sani-
Con pump unattended
while in use. DO NOT
allow the pump to run
dry for any period of
time. Damage to the
pump impeller and
Sani-Con system will result and void
manufacturer's warranty.
100220
100220b
133