Table of Contents
Advertisement
INFORMATION
Replacement bulb number is
accurate at time of printing. Confirm
replacement bulb number before
ordering or obtaining a replacement.
Using a clean cloth or piece of tissue
grasp the new bulb and align the
prongs on the bulb with the slot on
light socket.
Push bulb in and rotate to lock position.
Gently squeeze lens cover and insert
tabs on cover into fixture.
CAUTION
DO NOT touch the incandescent bulbs
while on. Allow bulb to cool down
before replacing because a hot bulb
can cause a burn.
Interior Halogen
To Remove:
Grasp light fixture and pull down
slightly then tilt fixture to one side.
This will allow one spring clip to come
out.
1
CAUTION
Push spring clip inward with a finger
as clip is being eased out. If this is not
done spring clip can snap back on
fingers.
Tilt fixture to other side
and ease the other spring
080475c
clip out.
Unscrew the light lens
counterclockwise and
remove.
Carefully grasp bulb and
pull from socket.
The bulb replacement is 12V 10W CE.
INFORMATION
Replacement bulb number is
accurate at time of printing. Confirm
replacement bulb number before
ordering or obtaining a replacement.
Use a clean cloth or piece of tissue to
grasp new bulb. DO NOT touch bulb
directly as this can cause a "hot spot"
and result in immediate bulb failure.
Align contacts of bulb with terminals in
fixture base. Insert bulb until contacts
are firmly seated.
To Reinstall:
Align tabs on light lens with slots in
fixture base. Rotate lens clockwise
until light lens locks into place.
Fold up both spring clips and insert
light fixture into opening. Once in
opening the spring clips will expand
and lock light fixture into place.
CAUTION
DO NOT touch halogen lighting while
on. They can cause a burn. DO NOT
touch replacement bulbs. Oil in the
hands can cause a "hot-spot" to occur.
If the bulb is touched, allow it to cool
and clean the bulb with alcohol.
Map Light
Operation:
Turn the map light on by
pressing the On/Off switch
on the map light. The map
060200d
light pivots left and right
to allow illumination of
different areas.
In addition a wall switch
is located next to the bed
which also turns the map light on/off. For
the light to operate from the wall switch, the
On/Off switch on the map light must be on.
To Replace a Bulb:
Carefully push in on the bulb and turn
counterclockwise.
Pull bulb from the socket.
Bulb replacement is 1383 12V. To re-
install align the two pins on the bulb
with the two channels on the socket.
Insert the bulb and turn clockwise.
INFORMATION
Replacement bulb is accurate at time
of printing. Confirm replacement bulb
number before ordering or obtaining a
replacement.
060326
Advertisement
Chapters
Table of Contents
Troubleshooting
