Toilet - Monaco 2009 Knight Owner's Manual

Connect a non-potable water hose with

pressure regulator to the water source.
Connect the other end of the water hose
to the Tank Flush fitting.
Open the solid waste (black tank) valve.

Turn on the water source and allow the

water to rinse the black tank at least three
minutes. DO NOT operate the system
unattended.
Turn the water off, disconnect the non-

potable hose and pressure regulator.
Store the hose and regulator for future
use.
Turn the Sani-Con pump on and allow

black tank to empty.
Turn the Sani-Con pump off.

Close black tank drain valve.

If applicable, the grey tank (liquid waste)

can be emptied at this time. Close grey
tank valve.
Store sewer hose and Sani-Con discharge

nozzle for travel. Secure termination cap
(required by law in some states).
If desired, add chemicals to the holding

tanks to control odor. Follow the
chemical manufacturer's directions.
Grey Water Bypass:
The grey water bypass system allows
continuous grey water flow. The liquid (grey)
waste uses gravity to drain from the tank
and bypasses the pump by going through the
bypass hose into the sewage service. The
bypass hose is the small hose connected at the
termination point of the dump valves and "T-s"
into the small flexible hose on the outlet side
of the macerator pump. The bypass system
is located inside the housing that covers the
sewer hose.
View with housing removed
Troubleshooting:
The house battery disconnect switch

must be on.
12 Volt DC power for the macerator

pump comes from the house batteries
and is protected with a 20 Amp
mini-breaker. The breaker is located
in the curbside electrical battery
compartment. Open the black box
above the batteries to access the mini-
breaker. Due to options and changes to
the motorhome, the amperage values
and items listed on fuse label will
change.

TOILET

The toilet uses water
from either the fresh water
tank or a city water supply.
The water pump must be
turned ON or connect the
motorhome to city water. The toilet flushes
directly into the sewage holding tank (black
040623
water).
CAUTION
To prevent accumulation of solids
below toilet, add several gallons of
water to the holding tank before use.
Most chemical mixtures for holding
tank odor control are poisonous.
Follow the product manufacturer's
directions and warnings when using
any holding tank additive.
CAUTION
DO NOT dispose of sanitary supplies
or other non-dissolving items into the
toilet. Facial tissue, wet strength tissue,
paper towels or an excess toilet tissue
can clog the tank or termination valve.
Pedal Flush
To add water to the toilet before using,

press and hold the pedal halfway until
the desired water level is reached.
060162ba
Generally, more water is required only
when flushing solids.
040466
040467
13