Table of Contents
Advertisement
To Empty the Black Tank (Solid Waste):
Close the black tank (solid waste) and
grey tank (liquid waste) valves.
Remove the terminal drain outlet cap.
Secure the flexible sewer hose from
the Sani-Con macerator pump to the
termination drain outlet by aligning
the sewer hose coupler tangs with
the terminal tabs. Twist the coupler
clockwise to lock it to the terminal
outlet.
Remove the drip cap at 1 ½" end of
discharge nozzle (see illustration).
WARNING
Be sure to
remove the
drip cap from
the Sani-Con
hose end (see
illustration).
Failure to do
so will result
in damage to
the Sani-Con
system.
CAUTION
If the
pump is
activated
while the
drip cap is
on the hose
end, switch
the pump
off (use the
Sani-Con
On/Off switch) and wait at least 30
seconds to allow pressure to dissipate
before removing the drip cap.
13
Periodically tighten all hose clamps.
Install discharge nozzle to the sewer
connection (dump station). Adapters
allow the discharge nozzle to fit a 3"
to 4" threaded or non-threaded sewer
connection. Ensure the discharge nozzle
is correctly installed prior to operation.
Open the solid waste (black tank) valve
by pulling outward.
Turn on the waste pump using the Sani-
Con switch located on Water Service
Center panel.
Push the test switch on the monitor panel
to read tank level. Allow the black tank
to empty.
When the black tank is empty, turn off
the Sani-Con pump and leave the black
tank valve open.
Store sewer hose and Sani-Con discharge
nozzle for travel. Secure termination cap
(required by law in some states).
If desired, add chemicals to the holding
tanks to control odor. Follow the
chemical manufacturer's directions.
040623b
To Empty the Grey Tank (Liquid Waste):
Secure the flexible sewer hose from
the Sani-Con macerator pump to the
termination drain outlet.
Remove the drip cap at 1 ½" end of
discharge nozzle (see illustration).
Periodically tighten all hose clamps.
Install discharge nozzle to the sewer
connection (dump ststion). Adapters
040516t
allow the discharge nozzle to fit a 3"
to 4" threaded or non-threaded sewer
connection. Ensure the discharge nozzle
is correctly installed prior to operation.
If applicable, close the black tank (solid
waste water) valve.
Open the grey tank valve.
Turn on the Sani-Con pump. Allow the
grey tank to empty.
Push the test switch on the monitor panel
to read tank levels.
If applicable, the black tank (solid waste)
can be emptied at this time.
Turn the Sani-Con pump off.
Close the grey tank drain valve and, if
applicable, the black tank valve.
Store sewer hose and Sani-Con
discharge nozzle for travel. Secure
termination cap (required by law in some
states).
If desired, add chemicals to the holding
tanks to control odor. Follow the
chemical manufacturer's directions.
Using Tank Flush:
WARNING
DO NOT operate the flush system
unattended. Flooding may occur. Use
the tank flush system each time the
holding tanks are cycled. Failure to
routinely use the flush system will
result in a clogged spray nozzle. Turn
off the water supply when finished
flushing the tank.
Secure the flexible sewer hose from
the Sani-Con macerator pump to the
termination drain outlet.
Remove the drip cap at 1 ½" end of
discharge nozzle (see illustration).
Periodically tighten all hose clamps.
Install discharge nozzle to the sewer
connection (dump station).
Advertisement
Chapters
Table of Contents
Troubleshooting
