Hide-A-Bed Air Mattress (Optional); Select Comfort Air Mattress (Optional) - Monaco 2009 Knight Owner's Manual

Hide-A-Bed Air Mattress (Optional)

The air mattress inflates and deflates in a
matter of seconds. Inflate the mattress by using
the electric inflation pump that operates from
any 120 Volt AC outlet. For ease of operation,
position the sofa so that accessing an electrical
outlet is convenient.
To Inflate Mattress:
Open sofa and allow the mattress to lie

flat.
Unzip the corner of the mattress labeled

"Air Pump Access"
Remove valve cap by turning cap

counterclockwise.
After cap is removed, insert pump

motor and turn clockwise until pump is
engaged.
Plug in pump motor and inflate to full,

approximately 60 seconds. A motor pitch
change occurs when mattress is full.
Remove pump and reseal valve cap by

turning clockwise.
Zip the Air Pump Access cover closed.

The bed is now ready for linen.
To Deflate Mattress:
Remove bed linen.

Unzip the corner cover of the mattress

labeled Air Pump Access.
Open deflation valve by lifting valve

latch. Allow mattress to deflate.
112
Once mattress is deflated swing valve

to closed position. DO NOT lock
valve closed by locking the valve. Air
trapped in the mattress could cause
damage.
Zip the Air Pump Access cover closed

and close the sofa.
NOTE
DO NOT close deflation valve when
closing the sleeper mechanism.
WARNING
The electric inflation pump is for
indoor use only. DO NOT use near or
place in water. Keep infants and small
children away from pump and product
when not fully inflated. Partially
inflated product can cause suffocation.
Removing the Mattress Valve:
Open deflation valve by lifting up on

valve tab.
020260d
Remove old valve by lifting the black

plastic on the outer edge of the valve
toward the center. The valve will then
lift out.
Installing New Mattress Valve:
To install the new valve, first open the

replacement.
Once open, seat the hinge area on to

the hinge support, then squeeze the
vinyl towards the center of the mattress
opening.
Feed the vinyl through the opening of

the new valve.
Once installed make sure there are no

bulges in the vinyl. Use thumb to make
sure that it is smooth.
Next, lock the replacement shut.


Select Comfort Air Mattress (Optional)

The Air Mattress uses uniquely designed
air chambers to provide a gentle cushion of
support which can be adjusted for comfort and
firmness. The mattress can be personalized to
an owner's ideal comfort level.
031117d
Air Mattress Pump Air Mattress Remote
To Operate Air Mattress:
The air mattress requires 120 Volt AC power
from shore power or the generator to operate.
The inverter can be used, but battery power
may be depleted by continued use.
Ensure the battery-cut out switch is on and
the house batteries are charged.
What is a Sleep Number:
It is a setting between 0 and 100 that

represents the ideal combination of
mattress comfort, firmness, and support
for each person's body.
Use the initial Sleep Number on the

remote as a starting point.
Setting the Sleep Number:
Lie on the bed in a normal sleep

position.
Press and release any remote button

to display the current Sleep Number
setting.
031117c