Listening To The Fm Radio - Jensen JiMS-252i User Manual

W166-R(JiMS-252i)_GB_ES IB.indd 10 18 -

LISTENING TO THE FM RADIO

FM Antenna
Fully extend the FM antenna wire for the best FM radio reception.
Radio Tuning
1. Press the button to turn on the unit.
2. Tap the / FUNCTION button on main unit or FUNC button on remote to select FM radio mode,
the radio indicator FM displays.
3. To manually tune to a desired station, repeatedly press the TUN +/-
4. To automatically search for stations with strong signals, press and hold the TUN+/-
button until the frequency digits on display begins to scan then release the button. The tuner will
stop on the first strong signal it finds.
5. Press the Volume Up (+) and Volume Down (-) buttons on the unit or remote to adjust the volume output level.
6. If necessary, you may tap the ST./MONO button to select stereo (the stereo indicator
or mono (the indicator is off) reception.
7. Press and hold the / FUNCTION button on main unit or tap
turn unit into standby mode after listenning. The power status LED lights off.
Notes:
- Manual tune to select weaker stations that might be skipped during automatic tuning.
- If the automatic tuning does not stop on the exact frequency of the station, for example, it
stops on 88.9 MHz instead of 88.8 MHz, use the manual tuning method to "fine tune" to the
exact frequency of the desired station.
- If you dock an iPod or iPhone for charging while listening to the radio, the unit will
automatically switch to iPod mode for authentication. Wait a few seconds, then tap the
FUNCTION button twice to switch the unit back to FM radio mode.
Radio Preset Stations
The unit allows you to store up to 20 FM stations for easy recall at any time.
Setting Preset Stations
Auto Preset
1. Tap the button to turn on the unit.
2. Tap the FUNCTION (FUNC) button to select FM radio mode.
3. Press and hold the MODE / MEM button for auto preset. The tuner will automatically scan for stronger
radio stations from low frequency to high frequency and then store them in the preset channels.
Manual Preset
1. Tap the button to turn on the unit.
2. Tap the FUNCTION (FUNC) button to select FM radio mode.
3. Tune to the radio station you want to store in memory by using the TUN +/-
4. Tap the MEM button. The preset channel number appears on display and blinks.
5. To select desired preset station number, tap the
button on the remote control.
6. To confirm preset location, tap the MEM button.
7. Repeat steps 3 to 6 to store other stations if necessory.
Notes:
- There is a 5 seconds delay when programming, after 5 seconds, the unit will automatically
switch back to normal tuner mode.
- You can overwrite a preset station by overwriting and storing the new frequency in its place.
Recalling a Preset Station
1. Tap the button to turn on the unit.
2. Tap the FUNCTION (FUNC) button to select FM radio receiving mode.
3. To select desired preset channel, tap the PRESET button and then the
main unit or press the PRESET +/- button from the remote control directly.
size:148x210mm,80gms book paper,BK+BK.
10 27 2012-2-28 8:36
GB
/ button.
/
displays)
button on the remote control to
/ button.
/ button on the main unit or PRESET +/-
/ button from the
10
ES