Listening To Your Iphone/Ipod - Jensen JiTS-260i User Manual

LISTENING TO YOUR iPhone/iPod

PLAYBACK
1.Push down on the back of the docking bay cover to open it and expose the docking bay.
2.Use the iPod adaptor included with your iPod (if needed) and insert it into the docking area.
No adaptor is required if you use an iPhone. Your iPod/iPhone can now be inserted into the
docking bay by placing the connector on the bottom of the iPhone/iPod onto the connector
in the docking bay.
Note: Please be careful when seating the iPhone/iPod into the docking bay to avoid damaging
the 30-pin connector on the iPhone/iPod or in the docking system.
3.Turn on the POWER ON/OFF switch on the back of the unit, and the standby indicator lights.
4.Press the STANDBY button to turn on the unit. The standby indicator goes off and the
function indicator lights.
5.Press the FUNCTION button or iPod button on the remote control to select iPod/Music
mode (the Red indicator lights on the FUNCTION button) and then press the
PLAY/PAUSE
6.Press the PLAY/PAUSE
7.Press the VOLUME Up (+) / Down (-) button to adjust your desired volume level
8.Press the BASS + / - button on the remote control to adjust the desired bass level.
9.Press the or
Press and hold the
10.To remove the iPhone/iPod from the unit, press and hold the PLAY/PAUSE
the remote control for five seconds to switch off the device and then gently remove it from
the docking connector.
11. Press the STANDBY button to place the unit into standby mode. You can also
completely turn off the power to the unit by switching the Main POWER ON/OFF switch
on the back of the unit to the OFF position.
12. Close the dust cover after use.
iPod/iPhone playback function (Using Remote Control):
Press the MENU button, SELECT button and
the iPod menu, scroll menu up/down and enter selection.
Note: 1.The iPod Menu Control function will work with most iPod touch/iPhone models in
iPod mode. Please make sure your iPod/iPhone is in iPod/Music mode. The function will
NOT work if the iPod/iPhone is on the MAIN or LOCKED screen.
2.The iPod menu navigating function of remote control will work on most iPhone or iPod
models except for the iPod nano 6th gen.
Press the REPEAT button repeatedly to cycle through the repeat options (repeat 1,
repeat all and repeat off) of your iPhone/iPod.
Press the SHUFFLE button to enable or disable the shuffle play function of your
iPhone/iPod.
Charging
Your iPhone/iPod will charge in all function modes when docked,
NOTE: To prevent damaging the dock connector, never twist the iPhone/iPod when
inserting or removing it.
button to start playback.
button on the remote control to pause or resume playback.
button on the remote control to select the desire music track.
or button for fast-rewinding or fast-forwarding during playback.
/ buttons on the remote control to control
8
button on