Getting Started - Jensen JiMS-252i User Manual

W166-R(JiMS-252i)_GB_ES IB.indd 5 18 -
size:148x210mm,80gms book paper,BK+BK.
32 5 2012-2-28 8:36
ES

GETTING STARTED

Clock setting battery back-up
The battery back-up compartment is located on the bottom of the unit.
(1) Remove the battery compartment door.
(2) Follow the polarity diagram shown inside the compartment and install 2 x AAA (UM-4) batteries (notincluded).
(3) Replace the battery compartment door.
NOTE: Only use a well-known brand of battery to ensure the longest life and best performance.
Warnings:
- Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
- Be sure that the batteries are installed correctly. Wrong polarity may damage the unit.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel- cadmium) batteries.
- Only batteries of the same or equivalent type as recommend are to be used.
- If the unit is not to be used for an extended period of time, remove the battery.
- Do not dispose of batteries in fire, battery may explode or leak.
- Danger of explosion if battery is incorrectly replaced.
Remote Control
The remote control operates on one CR2025 battery (included). To activate the
remote control, remove the insulation tab inserted in the battery compartment.
When the operation of the remote control becomes intermittent or unsatisfactory
replace the original battery with a new 3-volt lithium battery.
1.) Slide out the battery holder from the remote control case.
2.) Replace the 3V CR2025 battery. Be sure the battery is installed correctly. The
remote will not work if the battery is installed with the wrong polarity.
CAUTION: Danger of explosion if the battery is replaced incorrectly. Replace only with the same type battery.
3.) Insert the battery holder back into the battery slot.
NOTE: Only use a well-known brand of battery to ensure the longest life and best performance.
Speaker Connection
Unpack the unit carefully. The speaker wires are already attached to main unit. Handle with care to
avoid damaging the wires. Place the left speaker on the left side of the main unit and place the right
speaker on the right side of the main unit.
AC-DC Adaptor connection
The unit is powered by an external AC-DC Power Adaptor (included) with output DC12V / 2000mA.
(1) Insert the adaptor's DC output plug into the DC IN jack at the back of the unit.
(2) Plug the adaptor into an ac main outlet.
NOTE: This unit is not magnetically shielded and may cause color distortion on the screen of some TVs
or video monitors. To avoid this, you may need to move the unit further away from the TV or monitor if
unnatural color shifts or image distortion occurs.
Pivoting Speaker Set-up
The top part of both speakers are designed to pivot to the left or right and direct the sound in different
directions. You can twist the upper part of the speaker to a maximum angle of about 60 degrees in
either direction to obtain a wider sound field around the room.
Top View
Twist Upper Part of Left-Speaker Main Unit
GB
MADE IN CHINA
CR2025
OPEN
PUSH
RELEASE
Twist Upper Part of Right-Speaker
5