Listening To The Fm Radio; Remote Control - Jensen JiSS-20 Owner's Manual

LISTENING TO THE FM RADIO

Turn on the unit and press the function selector to switch to RADIO mode. The Power ON/OFF
1.
indicator and RADIO indicator will light to show the unit is in Radio mode.
FM stations can be auto scanned by pressing the Radio scan button. Press the button again to
2.
advance to the next station.
Once you reach th end of the FM band, press the rest button to restart the scanning from the beginning.
3.
Note: To obtain the best FM radio reception, fully extend the FM antenna wire located on the back
of the unit.
LISTENING TO A NON-DOCKING iPod OR OTHER
DIGITAL AUDIO DEVICE
If you are using an iPod without a docking port or other MP3/digital audio player, you can still play it on
the JiSS-20 via the AUX IN jack.
Turn on the unit and press the function selector to switch to AUX mode. The Power ON/OFF indicator
1.
and AUX indicator will light to show the unit is in AUX mode.
2. Plug one end of the 3.5mm audio cable (included) into the headphone or Line out jack on your
player. Plug the other end of the cable into the unit AUX IN jack located on the back of the JiSS-20.
3. Turn on the player.
Use the volume up/down buttons on the JiSS-20 to adjust the main volume. You may need to adjust
4.
your player volume if it is connected via the headphone jack of your audio device.

REMOTE CONTROL

To use the remote control, please ensure the remote control battery CR2025 (included) is installed
properly.
Replace the remote control battery when it stops working. It is highly recommended to use a good
quality Lithium cell.
Note:
The battery isolator paper must be removed prior to use.
!
Room lighting and battery life can affect the operating range of the remote control.
!
6