Listening To Radio - Jensen JiSS-120i User Manual

1. Set the FUNCTION selector to RADIO position.
2. Set the BAND selector to AM or FM for the desired radio band.
3. Tune to your desired station with the TUNING knob. If FM mode is selected and you
tune to a FM Stereo station, the FM STEREO Indicator will light.
4. Adjust the VOLUME control to obtain the desired sound level from the Built-in
Speakers.
5. To turn the Radio off, set the FUNCTION selector to the STANDBY position.
HINTS FOR BEST RECEPTION:
AM - The AM antenna is located inside the cabinet of the unit. If AM reception is weak,
change the position of unit until the internal antenna picks up the strongest signal.
FM -To insure maximum FM tuner reception, the telescopic FM antenna should be fully
extended and rotated to obtain the best possible station reception.
NOTES: 1). If you want to charge your iPod/iPhone while listening to the FM radio, the FM
stereo indicator will be covered by the iPod and iPhone when docked.
2). You cannot charge your iPod/iPhone while listening to the AM radio.
This CD player not only plays commercial CDs, but also self-compiled CD-R/RW discs. Do
not attempt to play CD-ROM, CDI, VCD, DVD or computer CDs.
NOTES ON CD-R/RW DISCS
• Because of non-standardized format definition/production of CD-R/RW, playback
quality & performance are not guaranteed.
• Manufacturer is not responsible for the playability of CD-R/RW due to recording
conditions such as PC performance, writing software, media ability, etc.
• Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a
malfunction.
INSERTING AN AUDIO CD DISC
1. Lift up the CD door to fully open it and carefully place an
audio CD disc with its label side facing upward in the CD
compartment and gently close the CD door.
2. Set the FUNCTION selector to CD position.
3. The unit will read the CD disc automatically, display will
briefly show flashing "- -" and then the total number of tracks
on the CD after a few seconds.
4. If no disc is inserted or if the inserted disc is not recognized, the display will show the
message "No". If the CD door is not closed, the display will show "00".
NOTES:
Keep the CD disc tray closed when the system is not in use to prevent dirt and dust

from entering the CD mechanism.
Never place more than one CD in the CD tray. If two discs are loaded at the same

time, the CD mechanism may jam and / or the discs themselves may be damaged.

LISTENING TO RADIO

CD OPERATION
- EN 8 -