Auxiliary Input - Jensen JiMS-252i User Manual

W166-R(JiMS-252i)_GB_ES IB.indd 11 18 -
size:148x210mm,80gms book paper,BK+BK.
26 11 2012-2-28 8:36
ES
Radio Broadcast System Selection
If this unit is used in a different country with slightly different radio broadcast systems, you can adjust
the system to select USA, EU, Japan and Australia broadcasts.
1. Turn the unit to standby mode, tap the MODE button repeatedly until the display shows the blinking
"USA", "EUr", "JAP" or "AUS" indicator.
2. Tap the VOLUME + / - button to select one of the following broadcasting systems.
USA's Radio Broadcast System FM 87.5 – 108 MHz, 0.1MHz tuning step
EU's Radio Broadcast System FM 87.5 – 108 MHz, 0.05MHz tuning step
Japan's Radio Broadcast System FM 76.0 – 90 MHz, 0.1MHz tuning step
Australia's Radio Broadcast System FM 87.5 – 108 MHz, 0.05MHz tuning step
3. To save the setting and exit the setting mode, tap the MODE button.

AUXILIARY INPUT

This unit provides an auxiliary audio signal input for connecting external audio devices MP3 players,
CD players and listen to your external source through the speakers of this system.
1. Use an audio cable (not included) with one 3.5 mm stereo plug on each end of the cable
2. Plug one end into the AUX-IN Jack located at the back of the unit.
3. Plug the other end of the cable to a Line Out Jack or Headphone Jack of your external audio
device.
4. Turn on the external audio device.
5. To select auxiliary audio input, tap the FUNCTION (FUNC) button until the "AUX" indicator
displays.
6. The volume level can now be controlled through the main unit. Operate all other functions on the
auxiliary device as usual.
Note:
- If you connected the Line-Out Jack of your external device then you only need to adjust the volume
control of this unit. If you're connected the Headphone Jack of your external device, then you may
need to adjust both the volume control of your external device and the volume control of this unit to
find the most desirable volume setting.
- If you dock iPod or iPhone for charging during listening to AUX mode, the unit will automatically
switch to iPod mode for authentication. Wait for few seconds, then tap the FUNCTION button once
to switch unit back to AUX mode.
- Press and hold the button on the main unit or tap
system into standby mode when you finish listening. Don't forget to switch off the power of your
external device as well.
GB
button on the remote control to place the
11