Radio Operation - Jensen JiLS-525iB User Manual

FM ANTENNA
Fully unwrap and extend the FM antenna wire for the best FM radio reception.
RADIO TUNING
1. Tap the button to turn on the unit.
2. Tap the FUNCTION button to select FM radio mode. The FM radio mode indicator LED
turns on.
3. To manually tune to a desired station, repeatedly tap the TUNE + / - button.
4. To automatically search for stations with strong signals, press and hold the TUNE + / -
button until the frequency digits on display begins to scan then release the button. The
tuner will stop on the first strong signal it finds.
5. You may tap the FM ST/MO button to select FM radio Stereo or Mono receiving mode,
where the stereo indicator "
NOTES ON FM RECEPTION:
- Manual tune to select weaker stations that might be skipped during automatic tuning.
- If the automatic tuning does not stop on the exact frequency of the station, for example,
it stops on 88.9 MHz instead of 88.8 MHz, use the manual tuning method to "fine tune" to
the exact frequency of the desired station.
- If you notice interference in your FM reception while charging your iPhone/iPod in
the dock, make sure the FM wire antenna is fully unwrap and extended. If the interference
continues, remove your iPhone/iPod from the charging dock while using the FM radio, or
use the USB charging port on the back.
PRESET RADIO STATION CHANNEL
The unit allows you to store up to 20 FM stations for easy recall at any time.
1. Tap the button to turn on the unit.
2. Tap the FUNCTION button to select FM radio mode.
3. Tune to the radio station you want to store in memory by using the TUNE + / - button.
4. Tap the MEMORY button, where the preset channel number appears on display and
blinks.
5. To select desired preset station number, press the TUNE + / - button.
6. To confirm preset location, tap the MEMORY button.
7. Repeat steps 3 to 6 to store other stations.
Notes:
1.) There is a few seconds delay when programming, after this delay time, the unit will
automatically switch back to normal tuner mode.
2.) You can overwrite a preset station by overwriting and storing the new frequency in its
place.
RECALLING A PRESET STATION
In radio mode, press the PRESET button then press the TUNE + / - button from the main unit
(or the CH + / - button from the remote control) to select the desired preset radio channel. The
preset channel number will appear on display.

RADIO OPERATION

" and mono indicator "
12
" display respectively.