Radio Operation; Listening To The Radio - Jensen HD Radio JiMS-525i Owner's Manual

The following procedures can be accomplished by using either the remote or the controls on the main
unit.

Listening to the Radio

Note: When entering the Radio function mode, the words "PLEASE WAIT TO TURN ON RADIO" will
appear first on the bottom row of the Display and then the Band and Frequency Reading will be
shown in the Display after one or two seconds.
1. Press the Button to turn on the unit.
2. Press the FUNCTION Button to operate the unit in radio mode.
TO:
Switch between AM/FM band
Select FM MONO or ST mode
Scan radio station automatically
Stop auto-tuning
Scan radio station manually
Control the volume
Adjust the EQ
Stop output from the speakers
Resume output from the speakers MUTE Button again
Note:
1. Frequency reading will change to the time 1 minute after the system has entered the radio function
mode. The FM Stereo Indicator will stay on in the Display in FM stereo mode.
2. To check the station frequency, press the SET/FM MODE Button once and again in order to keep the
station in stereo mode. Station frequency will be displayed for about 1 minute and revert to current
time again.
3. When listening to an FM station, fully extend the antenna to insure maximum tuner sensitivity.
4. Automatic tuning depends on the signal strength of the broadcasting station, so weak stations are
sometimes skipped. Tune manually to find the weak stations. With stronger stations, the tuner may stop
before it reaches optimum setting for that station. Adjust manually for the best reception if needed.
5. For FM reception, the Radio provides FM MONO/STEREO selection. In stereo mode, the unit will
automatically switch to stereo when a strong FM stereo broadcast is received and will indicate "ST" in
the Display.
6. To receive a weaker (noisy) FM station, press the SET/FM MODE Button to switch to MONO mode.
The reception may improve, but the sound heard is monaural (MONO).
7. The sound equalization can be adjusted for optimum sound reproduction depending on the style of
music you are playing. By pressing the EQ button, you can switch between ROCK, POP, CLASSIC,
JAZZ, BASS or NORMAL equalization to suit your taste.
Rock Pop

RADIO OPERATION

PRESS:
BAND Button repeatedly
SET Button repeatedly
or Hold Buttons for 1 second
or Buttons again
or Buttons repeatedly
VOLUME + or – Buttons
EQ Button repeatedly until the desired EQ shown in the Display
MUTE Button once
Classic Jazz Bass Normal
- 9 -
Radio iPod Aux