Battery Care; Listening To Ipod/Iphone/Ipad - Jensen JiPS-200i User Manual

installed correctly. The remote will not work if the battery is installed with the wrong
polarity.
CAUTION: Danger of explosion if the battery is replaced incorrectly. Replace only with
the same type battery.
3.) Insert the battery holder back into the battery slot.
NOTE: Only use a well-known brand of cell battery to ensure the longest life and best
performance.

BATTERY CARE

i. If the unit is not used for an extended period of time, remove the battery. An old or
leaking battery can cause damage to the unit and may void the warranty.
ii. Do not dispose batteries in fire. Batteries may leak or explode.
iii. Do not try to recharge batteries that are not intended to be recharged; they can
overheat, rupture and leak (Follow battery manufacturer's directions).
iv. Only an adult should replace the battery. Do not leave it lying around where a
young child or pet could play with or swallow it.
CONNECTING
1.) Push on the Sliding Docking Station to slide it out, place your iPod/iPhone/iPad into
the docking port by placing the connector on the bottom of the iPod/iPhone/iPad
onto the connector in the docking station.
Note: Please be careful when placing the iPod / iPhone/iPad into the docking port to
avoid damaging the 30-pin connector on the iPod/iPhone or on the docking
system.
2.) Turn the Main POWER ON/OFF switch on the rear of the unit to the ON position.
3.) Press the PLAY/PAUSE
iPod/iPhone/iPad play back. The iPod/iPhone/iPad will also start charging
immediately.
4.) Adjust the sound level by pressing the VOLUME - / + buttons located on the back of
the main unit or on the remote
Note: The volume level cannot be adjusted using the volume control on your
iPad/iPod/iPhone after it has been docked.

LISTENING TO iPod/iPhone/iPad

button on the remote control to start the
control.
6