Edge Sensor (Contact Sensor) Installation; Manual Release - Viking R-6 Installation Instructions And Use & Care Manual

IMPORTANT SAFETY INFORMATION IMPORTANT SAFETY INFORMATION
WARNING - Not following these instructions may cause severe injury or death to persons.

Edge Sensor (contact sensor) Installation

For Secondary Entrapment Protection
Radio Station
N.O.
COM
N.C.
Mag.
Lock
Edge sensor or like must be installed to reduce the risk of entrapment.
Use only Miller Edge 3-sided activation type MGR20 or MGS20 to comply with UL325
Motor Sensor
Low Battery
One or more contact sensors shall be located on the inside and outside leading edge
Power
Radio
of a swing gate. Additionally, if the bottom edge of a swing gate is greater than 6
Rec.
Charger
inches (152 mm) above the ground at any point in its arc of travel, one or more
contact sensors shall be located on the bottom edge.
1. A hardwired contact sensor shall be located and its wiring arranged so that the
communication between the sensor and the gate operator is not subjected to
mechanical damage.
2. A wireless contact sensor such as one that transmits radio frequency (RF) signals
to the gate operator for entrapment protection functions shall be located where
the transmission of the signals are not obstructed or impeded by building
structures, natural landscaping or similar obstruction. A wireless contact sensor
shall function under the intended end-use conditions.

Manual Release

Loop Connector
off
1sec
Hold Open
MAX
UL Safety Center
Sensor Loop Loop
Fail
Fail Safe/Secure
Safe/Secure
Remove Hat
Locking Handle
(in Unlocked
Position)
TECHNICAL SUPPORT 1 800 908 0884
Open Commands Guard Station
60sec
Open Stop
30sec
Timer
Limit
min.
0
3
1.5
Obstruction
Overlap Delay
Sensor
When manual operation is required:
1. Remove the Hat
2. Lift the Locking Handle.
3. Remove the Clutch Key
To reengage the gate operator:
1. Align the Clutch and the notches on the
Output Shaft.
2. Insert the Clutch Key.
3. Push down the Locking Handle.
4. Reattach the Hat.
Attention: Lock and release operations MUST
be performed with motor NOT RUNNING.
3-Sided Edge Sensor
3-Sided Edge Sensor
Master/Slave
Close
Limit
UL
Siren
Brake
7