Table of Contents
Advertisement
near one side while the belt is
tendenc
y to centre itself. If during use, the be
The pro
cedures are as below:
▲ first set speed at lowest position.
▲ second check the belt shifts to which side.
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using 6mm Hexagonal Wrench,
until the belt is centered itself; If belt shifts to left, tighten the left bolt and loosen the right bolt by using 6m
Hexagonal Wrench, until the belt is centered. When ad
is important to adjust the belt in half turn increment
8. Solutions for Failure Elimination
Failure
The power supply is connected
and
the
machine has started, however,
there is no any display.
All displays fail to work.
Operation stops automatically
and E1 is displayed.
Display
shows
operation, the strap, however,
operates improperly and suffers
from a cacophony.
The electric running machine
operates normally with no load
but halts midway.
The
display
normally or cannot display at all,
and the keys don't work.
WARRANTY REGISTRATION
Please visit the following link to complete the product warranty form online. Please visit
htt
p://warrantyform.lifespanfitness.com.au/
PLEASE NOTE: YOUR WARRANTY IS ONLY VALID IF YOU CAN PROVE YOU ARE THE ORIGINAL
PURCHASER ON THIS ITEM (i.e. a copy of the receipt, invoice, delivery date or internet confirmation).
running with no one on it. After a few minutes of use, the belt should have a
P
ossible Reason
1 ． The socket and
electric
running
2 ． The
3．The fuse is burned.
K
eys
improperly
emergency.
The self-maintenance
function
works suddenly.
a
normal The input voltage is too The input power should meet
low.
The
loose.
fails
to
work
The electronic meter is
influenced
external fa or.
lt continues to move toward one side, adjustments are necessary.
justing the belt using the 6 mm Hexagonal Wrenches, it
s. Over adjusting the belt can cause damage to the mat.
power supply is not
connected well.
socket
of
electric motor is not
connected well.
are
installed
in
of
system
strap
becomes
by
an
ct
Solution
1．Insert the socket again.
2
．Re-connect the socket.
3 ． Disconnect the power
supply and replace the fuse.
Perfect the installation.
1．Restart the electric running
machine
after
pressing
'STOP'.
2．
Restart the electric runn
machine after the po
supply
has
disconnected for
5min.
3．Replace the sensor.
the requirement.
Adjust the strap following the
specification.
Disconnect the power s
and switch off switches, and
restart the electric running
machine 5min later.
m
ing
wer
been
upply
10
Advertisement
Table of Contents
