Table of Contents
Advertisement
When Worn Action
When the RibbonMinder detects zero percentage of ribbon ink
remaining, the message display shows:
WHEN WORN ACTION
1. Press the
•
NO STOP ON 0% causes the printer to continue to print; the ribbon life
value will continue to decrease until –99% is reached.
•
NO STOP – BLINK causes the printer to continue to print; the ribbon
life value will continue to decrease until –99% is reached. The yellow
light bulbs will blink at 0% and continue until a new ribbon is installed.
•
STOP ON 0% INK causes the printer to stop printing at 0%, the light
bulbs to blink, the alarm to beep (if enabled), and an ATTENTION
RIBBON OUT message displays. Pressing ENABLE / HOLD allows the
printer to continue printing and no further Ribbon Out errors will be
reported. The ribbon life will decrease until –99% is reached.
2. Press ENTER when one of these parameters displays. SELECTED
appears on the bottom of the message display.
3. Press the
4. Press ENABLE / HOLD to place the printer in the enable mode.
Multiple Jobs
You may use the RibbonMinder function to run more than one job on the
same ribbon. To do this, the job rate must be known for each job before
printing.
To run multiple jobs, follow the procedures described in "Setting Up a New
Ribbon" on page 5–5. At the completion of each job, change the job rate
before starting a new job. Refer to your log of print jobs and their job rates.
5–12
RIBBON MINDER
switch to select one of the following When Worn actions:
switch until you are out of the program mode.
RibbonMinder
Advertisement
Table of Contents
