Table of Contents
Advertisement
Connect the Cables
1. Verify that the voltage source at the printer site conforms to the
requirements specified on page 2–2.
2. Make sure the printer power switch is set to O (off). (See Figure 2–7.)
3. Plug the power cord into the printer's AC power connector and into the
AC line receptacle.
4. Set the device address and device ID before connecting the twinax cable.
(Refer to page 3–26 and page 3–27.)
5. Connect the twinax cable (customer supplied) to either of the twinax
connectors on the smart "T" connector. Connect the smart "T" to the
15–pin "D" connector.
6. Set the coax / twinax switch to the twinax position.
2–10
Setting Up the Printer
Advertisement
Table of Contents
