Connect The Interface And Power Cords - Printronix ProLine 5 Series Manual

Connect the Interface and Power Cords

Before you connect the interface and power cables, verify the voltage source at
the printer site conforms to the requirements specified on
the printer power switch is set to OFF.
Interface and Power Cord Connections
I/O Cover
Host Interface
1
Connectors
Cable–Routing
Notches
1
See page 2–16 for illustrations of host interfaces available.
1. Make sure the printer power switch is set to O (Off).
2. Cabinet models only: Open the rear cabinet door, and remove the cover from
the I/O connector you have selected (See
Setting Up the Printer
Cabinet Model
AC Power Cable
Figure 2–1. Interface and Power Locations
page
OFF ON
AC Power
Connector
(Standard Units)
AC Power Connection
(Stacker Units)
Figure 2–1).
2–3. Make sure
Pedestal Model
Power Switch
AC Power Connector
Host Interface
1
Connectors
2–13