4 4
6 6
7.5.6
Code Length
Default: four digits
Under Code Length, you can change the number of digits used (4 or 6) for the Grand Master, the Manager and the Master. All other
PIN codes (user, Arm Only and maid) use one to six digits.
To access the Code Length menu:
1.
Select the Code Maintenance menu as described on page 7-57.
2.
Under Code Maintenance, press
the display:
3.
Press
length, the following message appears:
4.
Press
NOTE:
If you change the Code Length, all user codes are deleted and then have to be redefined or downloaded.
In the case of a six-digit code length, the factory default four-digit codes such as 1-2-3-4 (Grand Master), 0-1-3-3
(installer), and 0-2-3-3 (sub-installer) are changed to 1-2-3-4-0-0, 0-1-3-3-0-0, and 0-2-3-3-0-0.
If you change the Code Length back to four digits, the four-digit codes defined by the factory are restored.
7-62
6 6
to access the Code Length menu option. You see the following on
to select and then press
to change the factory default setting from [N] to [Y] and then press
to confirm your selection. If you change the code
.