Abus WIRELESS ALARM SYSTEM Installation Instructions Manual page 34

To access the System Label menu:
1. Select the main menu System as described on page 7-23.
2. In the System menu, press
display:
3. Select and configure the settings in the System Label menu as follows:
System Label:
Quick-Key
1 1 5 5 1 1
1 1 5 5 2 2
1 1 5 5 4 4
7-34
5 5
to get to the System Label menu option. You see the following on the
Menu option
System
Changes the display for the system name.
Partitions 1 – 3
to
Changes the display for partitions 1 to 3.
Example: The example below shows how to change the name of partition 1 to "Buero"
To assign the label "Buero" to partition 1:
2 2
1. Press for partition 1.
1 1
2. Press three times until the letter B appears on the display and then press
once to move the cursor to the right.
5 5
3. Press repeatedly until the letter u appears on the display and then press
again to move the cursor forwards.
4 4
4. Press repeatedly until the letter e appears on the display and then press
to move the cursor forwards.
5 5
5. Press repeatedly until the letter r appears on the display and then press
again to move the cursor forwards.
5 5
6. Press repeatedly until the letter o appears on the display and then press
again to move the cursor forwards.
6 6
7. Press twice for a space and then press
In this way, delete the unwanted characters.
Default
FUNKALARMANLAGE
Partitions 1–3
to move the cursor forwards.
Selection
Any 12
characters
Any 12
characters