Hitachi KP-FD500GV Operation Manual page 31

Address
Values (Factory setting 0) ： 0 to 32
・KNEE SLOPE ： Adjust knee slope
Command name
Address
Values (Factory setting 0) ： 0 to 159
(15) WHITE SPOT CORRECT ： Setting of whit spot correction
・MODE ： Select the mode
Command name
Address
Values (Factory setting 0) ： 0 "Off"
・LEVEL ： Setting for the threshold level
Command name
Address
Values (Factory setting 20: KP-FD500GV/F500GV
・DETECT ： Detect the white spot
Command name
Address
Values (write only)
・STATUS ： Status of detection
Command name
Address
Values (read only)
・SAVE ： Save white spots
Command name
Address
Values (write only)
(16) WHITE SPOT LIST ： Control of white spot list
・INDEX ： Specified the index of list
Command name
Address
Values (Factory setting 0) ： 0 to 63
・POSITION X (related to INDEX) ： Select the mode
Command name
Address
Values (Factory setting 0) ： 0
・POSITION Y (related to INDEX) ： Select the mode
Command name
Address
Values (Factory setting 0) ： 0
： A0FF0014 h
Setting value toward 0 side increase start level of knee and 32 side
decrease start level of knee.
： KneeSlopeRaw (Integer / Custom）
： A0FF0018 h
Setting value toward 0 side intensify effective of knee and 159 side weaken
effective of knee.
： WhiteSpotCorrectMode (Enumration / Custom）
： A0FF00A0 h
Not performance correction.
1 "On" Correct stored white spots.
： WhiteSpotCorrectLevelRaw (Integer /Custom）
： A0FF00A4 h
80: KP-FD202GV/FD145GV/FD140GV/FD83GV/FD33GV
100: KP-F202GV/F145GV/F140GV/F83GV/F33GV)
： 0 to 255 Set the threshold level of white spot detection in 8-bit gradation.
： WhiteSpotCorrectDetect (Command / Custom）
： A0FF00A8 h
： 1 When 1 is written, start white spot detection
The pixel having video level that exceeds LEVEL is judged as white spot.
： WhiteSpotCorrectStatus (Enumeration / Custom）
： A0FF00AC h
： 0 "NoDetect" It means there is no pixel having video level that exceeds threshold.
1 "NormalEnd" Normal end: It means that white detection is finished.
2 "OverDetect" Error end: It means that the number of detected pixels are exceeded
correctable number.
3 "Busy" It means while detecting.
： WhiteSpotCorrectSave (Command / Custom）
： A0FF00B0 h
： 1 When 1 is written, detected white spots are stored in the camera.
： WhiteSpotListIndex (Integer / Custom）
： A0FF00E0 h
The list of white spot position that will be corrected.
： WhiteSpotListPositionX (Integer / Custom）
： A0FF00E4 h
1 to WIDTH MAX
： WhiteSpotListPositionY (Integer / Custom）
： A0FF00E8 h
The white spot position is not registered in the specified index.
X-coordinate of registered white spot position is shown.
The white spot position is not registered in the specified index.
18