Battery Charging - Hayter Harrier 48 Owner's Handbook Manual

Electric start/variable speed
Hide thumbs Also See for Harrier 48:
Table of Contents

Advertisement

1.32

BATTERY CHARGING

WARNING - PREVENT ACCIDENTS : ALWAYS charge
the battery in a well ventilated area.
NEVER charge the battery near naked flames or direct heat.
ALWAYS switch off the mains electricity supply before dis-
connecting the charger from the battery.
ALWAYS use the battery charger supplied with the mower.
Battery charging should not be necessary during normal use. The
engine operation will automatically charge the battery. If the
mower is stored for a long period, recharging the battery may be
necessary to permit electric starting.
Charge the battery only when necessary.
To recharge the battery:
Disconnect the battery lead from the mower lead and then con-
nect the battery lead to the charger.
Connect the charger plug to the mains electricity supply and
switch on to charge the battery for a six hour period.
Switch off the mains electricity supply and disconnect the charg-
er plug.
Disconnect the battery lead from the charger and then connect
the battery lead to the mower lead.
IMPORTANT - PREVENT DAMAGE: NEVER connect the
battery charger to the engine lead as this will cause the
charger to be permanently damaged. Chargers damaged in
this manner will not be replaced under warranty.
CAUTION - PREVENT ENVIRONMENTAL DAMAGE:
The battery has a separate collection mark. This indicates
that the battery must be taken to an authorised disposal site.
It must not be disposed of with general waste.
MAINTENANCE
1.32
6 Hours
BATTERY
CS074
CS073
WS032
488142MT210999A

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

488t

Table of Contents