Engine Detail; Filling The Engine With Oil; Engine Oil Specifi Cations; First Time Battery Charging - Hayter Harrier 56 Autodrive VS ES B & S Operator's Manual

SETUP

Engine Detail

NOTE: Disconnect the spark plug lead and remove
the electric start button before performing any
maintenance procedures.
WARNING: Improper maintenance, use of non-
conforming replacement components, or the removal
or modifi cation of the engine may cause serious injury
or death.
(Refer to fi g 4)

Filling the Engine with Oil

IMPORTANT: Your mower does not come with oil in
the engine. Before starting the engine, fi ll the engine
with oil.
1. Move the mower to a level surface.
2. Remove the dipstick (1) by rotating the cap
counterclockwise and pulling it out.
3. Slowly pour oil into the engine oil fi ll tube (3). Do
not overfi ll. After adding oil, allow some time for
the oil to settle and then check the oil level.
4. Insert and tighten the dipstick (1).
5. Remove the dipstick and check the oil level. Check
Fig. 4
1. Spark Plug And Lead
5
6
Air Filter
2.
3. Engine Cover
7
4
4. Fuel Tank & Filler Cap
3
5. Oil Filler & Dipstick
2 6. Lithium-Ion Battery
1
7. Exhaust Guard
that the oil level is at the top of the full indicator (2)
on the dipstick.
• If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the oil
fi ll tube, allow some time for the oil to settle,
and repeat steps 3 through to 5 until the oil on
the dipstick is at the correct level.
• If the oil level on the dipstick is too high, drain
the excess oil until the oil on the dipstick is at
the correct level; refer to Oil Service.
6. Insert and tighten the dipstick securely.
(Refer fi g.5)
IMPORTANT: If the oil level in the engine is too low or
too high and you run the engine, you may damage the
engine.
Engine Oil Specifi cations
Engine Oil Capacity 0.54-0.60 L (18-20 fl oz)
Oil viscosity SAE 30 or SAE 5W oil when operating
in temperatures from -18°c to 38°c
API service classifi cation SJ or higher if classifi ed for service
Fig. 5
3
1
2
12

First Time Battery Charging

Remove the terminal strip from the battery before
inserting into the charger for the fi rst time.
The Lithium-Ion battery pack was partially charged
before shipment. To maintain charge and to prevent
damage while in storage, the battery pack is
programmed to enter a "sleep mode". A quick charge of
approximately ten (10) seconds is required to wake up
the battery. Refer to Before Operation - How to Charge
the Battery Pack for further information on how to
perform this operation.