Setting Menu - Kärcher WATERCLEAN 600 CD Service Handbook

APPENDIX
4.4.3

Setting menu

The calibration menu is used to adjust the sensors. The following functions are available:
Menu point:
1 t Cy LIM
2 t Cy alarm
3 t lack of pressure
4 t delay at start
5 t press. availabe
6 t disc. rinse
7 t rinse.interval
8 t concentrate
9 t disposal
10 t maintenance
11ps failure alarm
12 ps concentrate
13 ps type of tank
14 inputs
15 ps language
16 system reset
4.4.4 Diagnosis menu
The diagnosis allows direct display/manipulation of the input/output conditions for testing
purposes.
ATTENTION!!! Under these conditions, failure detection is not active.
Menu point:
1 digital input
2 digital output
3 lights
4 Cy permeate
5 temp. permeate
88
Function:
Numerical editing of t delay LIM
Numerical editing of t delay aaLIM
Numerical editing of t delay lack of pressure
Numerical editing of t delay at start
Numerical editing of t pressure failure
Numerical editing of t rinse
Numerical editing of t rinse interval
Numerical editing of t concentrate
Numerical editing of t disposal
Numerical editing of t maintenance
Selection of ps acknowledgment
Selection of ps concentrate
Selection of ps tank type
Setting of input types (valve with open rest pos./opener)
Selection of ps language
As soon as this function is called-in and acknowledged,
the internal hours meter will be deleted (set to 0)
Function:
Display of the current conditions of the digital inputs (see item 2.3).
Display is like a multiselection, but with the difference that the conditions
of the arguments cannot be set - they depend on the input conditions.
Manipulation of the digital circuit outputs (see item 2.3) by means of a
multiselection.
Manipulation of the lights (item 4.1.1) by means of a multiselection.
Permanent display of the current permeate conductivity. This display can
be cancelled by actuating one of the keys.
Permanent display of the current permeate temperature. This display can
be cancelled by actuating one of the keys.
WTC 600 LP / MP
Service Handbook 08.2004