Programming - Kärcher WATERCLEAN 600 CD Service Handbook

OPERATION OF THE SYSTEM
3.4.2.4

Programming

To start the programming, the covered
pushbutton (15/1) to the left of the "TIME OF
DAY" pushbutton (15/2) is to be pressed (a
circular indentation can be felt under the front
foil).The changing of the flashing positions is
carried out with the "ADVANCE" pushbutton
(15/3).
NOTE If a different adjustment than the
factory-setting is required, enter
and acknowledge by pressing
"MANUAL REGEN" (15/4).
When pressed continuously, the number values run through in double digits from the current
value to 99; by briefly pressing the pushbutton, the indication changes upward by the value 1.
Moving on to the next enter position is done by pressing the pushbutton mentioned in the 2nd
column in Table 17.
TIME OF DAY
ADVANCE
MANUAL REGEN
Covered pushbutton
Table 16 Input, preliminary filter control
Position
At the media filter:
1 Covered pushbutton
2 Covered pushbutton
At the activated carbon filter
1 Covered pushbutton
2 Covered pushbutton
At both filters
3 Covered pushbutton
4 Covered pushbutton
5 Covered pushbutton
Table 17 Programming table
32
1. Sets the time
2. Starts the programming of time steps
1. For changing of parameters during proggramming
2. Calls up the diagnosis (see Table 24) - press for 10 sec
1. Activates a manual regeneration
2. Runs step by step through the regeneration steps
Left of the „TIME OF DAY" pushbutton. Starts the programming.
Indication Description
0. 2 00
0. 2 00
0. 2 30
0. 2 30
FF01
200.0
200.0
1)
for sand filter and activated carbon filter
1
2
Figure 15 XP Controller
Media filter back-washing at 02.00 (minutes)
Media filter back-washing at 02.00
(full hours)
Backwashing of activated carbonfilter at
02.30 (minutes)
Backwashing of activated carbonfilter at
02.30 (full hours)
Time interval (in days) between 2 backwa
shings; FF01 means one backwashing per
day
Without function
Without function
Service Handbook 08.2004
WTC 600 LP / MP
3 4