Initial Startup - Kärcher WATERCLEAN 600 CD Service Handbook

Karcher water system user manual
Table of Contents

Advertisement

WTC 600 LP / MP
3.4.3.8

Initial startup

- Set the equipment to the operation operating mode (see 3.4.4)
- Set the drinking water capacity to 600 l/h
- For very cold water, the drinking water capacity of 600 l/h is not achieved: Then adjust the
maximum pump pressure of 21 bar (MP) or 14 bar (LP)
- Adjust the concentrate capacity to 200 l/h (for very cold water possibly somewhat more)
Closing the pressure control valve (11/1)
Pump pressure and concentrate pressure
increase
Drinking water amount increases
Concentrate amount increases
Conducting capacity increase
Table 20
Operating performance of the reverse osmosis when changing the pressure control
and concentrate control valve
For all changes of the settings to the system, the following values may not be
CAUTION
exceeded under any circumstances:
- Maximum pump pressure 21 bar (MP) or 14 bar (LP)
- Drinking water amount, 650 liters per hour maximum.
Untreated
Drinking water
water
capacity
1200 l/h
600 l/h
800 l/h
600 l/h
Table 21
Typical yields at maximum drinking water capacity and untreated water temperature
of 15 °C
NOTE
The drinking water capacity must never be set at more than 650 l/h, meaning that at
higher / lower feed-water temperature, the pump pressure and concentrate pressure
must be decreased / increased respectively by means of the ball valves (compare
figure 11).
Check the conductance value according to the reading on the display.
Demineralization rate: 94 – 99 %.
- Switch off the system at the main switch.
- Connect drinking water line in tank.
- Switch on the system at the main switch: Drinking water is produced and fills the tank.
- Tank filled: The level float switches off the solenoid valve and the pump until the switch of the
level float signals empty and the RO system switches on again.
Service Handbook 08.2004
OPERATION OF THE SYSTEM
Closing the concentrate control valve
(11/8)
Pump pressure and concentrate pressure
increase
Drinking water amount increases
Concentrate amount decreases
Conducting capacity increase
Concentrade
capacity
600 l/h
200 l/h
Yield
50%
75%
37

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Waterclean 600 lpWaterclean 600 mpWaterclean 600 pi

Table of Contents