Brick Installation / Installation Of Hb Porcelain Liners - Hb47Pl - Kingsman HBZDV4740 Installation Instructions Manual

INSTALLING BRICK PANELS FOR
MODEL HBZDV4740
1. Remove door glass from the unit by
unlatching the 2 latches on top of the unit..
2 Place optional front bridge ledge (#1) in the
area front of false bottom.
3. Place rear brick panel (#2) up against the
rear of the firebox.
4. Loosen screw holding brick clip in position,
move clip up out of the way and place side
brick (#3-4) up to rear brick and flush
against side wall of firebox.
5. Position clip over brick and tighten screw.
6. Install log set as per instructions and re-
install door.
Installation of HB Porcelain Liners - HB47PL
1. Remove Door from the fireplace by
unlatching the 2 latches on top of
unit.
2. Remove back Log H older by remov-
ing 3 screws from face of Log Holder.
The Log Holder will have to be rein-
stalled after the placement of the
Back Panel. For HB4736, remove
Brick Filler Panel (See Ref. 1).
3. Place Back Panel up against rear of
firebox by tilting top of Back Panel
towards you and sliding bottom of
Back Panel over burner system. For
HB47PL, use supplied screw to
attach Back Panel to firebox (See
Ref. 2).
4. Loosen screws holding Brick Clip in
place. Rotate Brick Clip out of the
way and slide Side Panel up against
Back Panel. Side Panel tabs should
engage top and bottom of Back
Panel (See Ref. 3). Rotate Brick Clip
down over Side Panel and tighten
screw.
5. Re-install Log Holder (and Brick Filler
Panel if applicable) removed in step
2. Install Log Set as per instruction
and re-install Door.
Brick Installation
15