Arris Touchstone TM702 User Manual page 16

Getting
Safety Started
Battery Slot
Battery
Installation Installation
TM702G 4-cell Battery Installation and Replacement
Use this procedure to install or replace a 4-cell backup battery.
Latch End
Battery Guide
Battery
Pull Strap
Touchstone TM702 Telephony Modem User's Guide
USB Ethernet
Drivers Configuration
1 Insert a finger into the latch opening, press down and pull back on the latch
holding the battery door (on the bottom of the Telephony Modem). Pull the
door toward you. Set the door aside in a safe place.
CAUTION
Risk of equipment damage
Improperly inserting the battery may damage the battery connector in
the Telephony Modem. Carefully follow the instructions in the next step
to avoid damage.
2 Hold the battery pack so that the guides on the battery align with the slots
on the Telephony Modem and slide the battery into the bay. The diagram on
the left shows the proper orientation.
Note: Batteries will not insert completely into the Telephony Modem if not
oriented correctly. The battery should slide into the bay without significant
force. Line up the slots in the battery bay with the guides on the battery
and apply even pressure on both ends of the battery.
WRONG
Usage Troubleshooting
WRONG RIGHT
Glossary
16