Arris Touchstone TM702 User Manual page 15

Getting
Safety Started
Receiver
Slots
Battery
Installation Installation
Battery
Opening
Note:
Hinge Tabs
Touchstone TM702 Telephony Modem User's Guide
USB Ethernet
Drivers Configuration
3 Push the battery pack into the bay until it seats into place. The following
diagram shows a Telephony Modem with a 2-cell battery pack installed. If
you are taking the battery out of the Telephony Modem, position
your finger in the battery opening area and use leverage to dislodge
the battery while pulling it straight back.
Note: The Telephony Modem will not begin operating until you apply AC
power.
4 Replace the door. To do so, place the hinge tabs of the battery door into the
receiver slots inside the Telephony Modem battery compartment on the
opposite end of the battery opening slot. Rotate the door toward the unit
until the latch snaps back into place.
Telephony Modems use a Lithium-Ion battery pack. Please recycle or dis-
pose of the battery responsibly and in accordance with local ordinances.
Usage Troubleshooting Glossary
15