Pace MBT250 Operation & Maintenance Manual page 25

Quick Start - Basic Operation
3. Perform the following to set handpiece tip temperatures.
a) Press the TIP SET Key.
b) Immediately press the Scroll Up (s) Key to increase the desired Tip Temperature. Press the Scroll
Down (t) Key to decrease the Tip Temperature.
c) Press the TIP SET Key.
d) Press the CH SELECT Key to select the next channel with a connected handpiece.
e) Perform steps 3a through 3d until the desired Tip Temperature has been set on all connected
handpieces.
4. Observe the Digital Readout as the Set Tip stabilizes at the desired Tip Temperature. Press the CH
SELECT Key to observe the Tip Temperature of handpieces connected to other channels. The
channel displayed on the Digital Readout is indicated by the illumination of the channel LEDs.
Read the "Operation" and "Calibration" sections of this manual to utilize the full
capabilities of the system. This is especially important when using large soldering
tips. Refer to the enclosed handpiece manuals for a complete description
handpiece capabilities.
NOTE
25