On-Screen Text Format - Barco ClickShare Installation Manual

6. Web Interface
• Information on supported "Established Timings" (most legacy timings, e.g. 720x400@70Hz, 88Hz; 800x600@56Hz, 60Hz,
72Hz, 75Hz; ... ; ...)
• Standard Timing Identifications (e.g. 1280x1024@60Hz, 1600x1200@60Hz,...)
• Detailed Timing Information. This is the "Preferred Timing" of the display and usually the most important information in the
EDID. It describes in full detail the preferred timing: pixel clock, active pixels, active lines, blanking, sync width, sync offset
(horizontal and vertical),...
About auto resolution
When the ClickShare Base Unit display output is put in auto mode, the display output timings will be based on the Preferred Timing
as described in the meeting room display or projector EDID.
About manually resolution setup
When resolution is selected manually, the timings of this resolution are taken from the information described in the meeting room
display or projector EDID. If the timing is not described in the EDID, the timing is generated by the Base Unit following the VESA
CVT standard with reduced blanking. The calculation is based on the official VESA calculation.
Example
For example when the meeting room display or projector has native WUXGA resolution (1920x1200), this will be described by the
Detailed Timing Information in its EDID. In this case Full HD resolution (1920x1080) will not be described by the EDID. When in auto
mode, the Base Unit will use the WUXGA timing as described in the EDID. But when putting it in 1920x1080 mode manually, the
timing will be according to VESA CVT with reduced blanking.
6.8

On-screen text format

About on-screen text
The language of the on-screen text of the display messages and startup page can be changed. Also the color, size and style can
be updated. The background color and the transparency can be adapted so that they match with the text layout.
How to start
1. Login to the ClickShare web interface.
2. Click the Setup tab (1) and then the Display tab (2).
The content of the Display tab is shown. The second pane shows the On-screen Text Format
Image 6-11
On-screen text
3. When changes are made, click Apply to activate the new settings.
To revert the changes, click Refresh Page.
Language selection
1. Select the language of the on-screen text. Click on the drop down box next to Language and select the desired language.
38 R5900004 CLICKSHARE 28/02/2013