4.6
Video signal connections to the Base Unit
C
AUTION
About Video signal connection
Depending on the local setup, a single screen or dual screen set up is possible.
For a single screen setup, a DVI or DisplayPort connection should be make between the Base Unit and the display.
For a dual screen setup, a DVI and a DisplayPort connection
To connect
1. Connect the Base Unit to the display(s) using display cables.
Refer to "1" on image 4-6.
Image 4-6
Display cables connection
Note: Display cables are not included in the ClickShare box at purchase.
Supported types of displays are:
-
Single Link DVI
-
DisplayPort
-
VGA: use the adapter included in the ClickShare box
-
HDMI: use an adapter cable (not included in the box)
When setting up a single display configuration, connect the DVI-I or the DisplayPort cable to the display.
When setting up a dual display configuration, connect the DVI-I connector with display 1 and the DisplayPort connector with
display 2.
R5900004 CLICKSHARE 28/02/2013
:
Make sure the Base Unit is installed properly before connecting.
4. ClickShare installation
1
21