Operational Parameters; Contents Of The Filter-Pure System; Tools Recommended For Installation - Watts Premier FILTER-PURE Installation, Operation And Maintenance Manual

Operational Parameters

Installation must comply with State and local plumbing regulations. Do not use with water that
is micro biologically unsafe or of unknown quality without adequate disinfection before or after
the system. System is intended to be installed using the cold water supply only.
Operational Temperature
Operating Pressure
pH Parameters
Flow Rate

Contents of the Filter-Pure System

√ 1 FILTER PURE Unit
√ 2 Filters
If any of the items are missing, please contact Watts Premier prior to installing

Tools Recommended For Installation

√ 1/2" Diamond Tipped Hole Saw bit for faucet opening (Porcelain Sinks) or,
√ 1/2" Hole Saw Bit for faucet opening (Most Counter Tops - excluding marble) or,
√ 1/2" Round Knock out Punch for faucet opening (Stainless Sinks)
√ 1 1/4" Adjustable Wrench
√ 1/2" Open End Wrench
√ Adjustable Pliers
√ Sharp Knife
√ 1/8" diamond tip bit, pilot hole
√ Electric Drill
√ Phillips Screw Driver
√ Phillips bit for electric drill
Maximum
100°F (37.8°C)
85 psi (5.98 kg/cm²)
10
0.5 GPM @ 60 psig
√ 1 Parts Bag
√ 1 Faucet Assembly
4
Minimum
40°F (4.4°C)
20 psi (1.406 kg/cm²)
5
√ 1 Green Tube
√ 1 Blue Tube