Table of Contents
Advertisement
Operational Parameters
Do not use with water that is micro biologically unsafe or of unknown quality without adequate disinfection
before or after the system. System is intended to be installed on the cold water line only.
Operating Temperatures:
Operating Pressure:
pH Parameters:
Iron:
TDS (Total Dissolved Solids)
Turbidity
Hardness:
Recommended hardness not to exceed 10 grains per gallon, or 170ppm. System will
operate with hardness over 10 grains but the membrane life may be shortened. Addition of a water
softener may lengthen the membrane life.
Water Pressure: The operating water pressure in your home should be tested over a 24 hour
period to attain the maximum pressure. If the incoming water pressure is above 85 psi a pressure
regulator is recommended and if over 100 psi then a pressure regulator is required.
Copper Tubing: Reverse Osmosis water should not be run through copper tubing as the purity of
the water will leach copper causing an objectional taste in water and pin holes may form in the tubing.
Watts supplies speciality filters (part number 107008) that can be used if copper tubing follows the
Reverse Osmosis unit. Be sure to follow any state or local regulations during installation.
Contents of Reverse Osmosis (RO) System
1 Tank
1 RO Module (complete with filters)
1 Pump - Installed
1 Manual
If any of the items are missing please contact Watts prior to installing.
Tools Recommended For Installation
√ 1 1/4" Diamond Tipped Hole Saw bit for faucet opening (Counter Tops/Porcelain & Stainless Sinks)
√ 1 1/4" Adjustable Wrench
√ 1/2" Open End Wrench
√ 5/8" Open End Wrench
√ Electric Drill
√ 1/8" diamond tip bit, pilot hole
√ 1/4" drain saddle hole
Maximum 100°F (37.8°C)
Maximum 85 psi (6.0 kg/cm
Maximum 11
Maximum 0.2 ppm
< 1800 ppm
< 5 NTU
INSTALLATION & STARTUP
√ Phillips bit for electric drill
√ Needle Nose Pliers
√ Adjustable Pliers
√ Sharp Knife
√ Phillips Screw Driver
2
)
1 Transformer
1 Parts Bag
1 Faucet Bag/Box
1 Filter Housing Wrench
Page 4
Minimum 40°F (4.4°C)
Minimum 40 psi (2.80 kg/cm
Minimum 2
2
)
Advertisement
Table of Contents
