Panasonic KX-TAW848 Programming Manual page 52
Advanced hybrid & wireless pbx
Hide thumbs
Also See for KX-TAW848:
- Features manual (584 pages) ,
- Feature manual (250 pages) ,
- Operating manual (174 pages)
Table of Contents
Advertisement
2.6 Help
Q
Can I perform initial setup of the PBX without being connected to the PBX?
A
•
Yes. This is possible in Batch mode.
Create a new system data file using 2.2.1 File—New, edit settings as required, and then
upload this file to the PBX later (see 2.5.2 Utility—File Transfer PC to PBX (SD Card)).
Maintenance Console Software
Q
How do I confirm the software version of the PBX or installed cards?
A
•
From 2.7.1 [1-1] Slot, click Summary. Summary information, including software
versions, is displayed for all cards installed in the PBX.
Q
Not all of the characters of a setting can be displayed because the column is
too narrow.
A
•
Move the mouse to the line between the names of 2 setting items, at the top of the table.
The pointer will change to a double arrow. Click and drag the line to the right until all
characters are displayed.
Card Status
Q
The status of a new card will not change to "INS".
A
•
With the new card installed, does the total number of extensions or CO lines exceed the
maximum supported by the PBX?
•
Is the type of card installed in the slot different from the card type set as "Pre-install" for
that slot? Confirm that the correct card is installed in the slot.
•
Is the card firmly and fully installed in the slot? Confirm that the card is installed correctly
in the slot.
•
Confirm that the card is not damaged.
Q
I cannot change an LCO port to INS status.
A
•
Is the card installed in the appropriate slot?
•
Is the card installed in the correct slot, but not functioning correctly?
Check the condition of the card.
•
Is the card itself in INS status?
Set it to INS status.
•
Is a CO line line connected to the appropriate port?
•
Is the port in FAULT status, even though a CO line is connected?
Run diagnosis on the relevant slot.
Q
How do I prevent newly installed cards automatically being changed to "INS"?
A
•
Change New Card Installation—Card Status for any Card in 2.7.13 [1-3] Option from
"In Service (INS)" to "Out of Service (OUS)".
Portable Stations
Q
I cannot register Portable Stations using the method described in Portable
Station [1-2].
52
PC Programming Manual
Advertisement
Table of Contents
