Panasonic KX-TAW848 Programming Manual page 387

SVM Cyclic Tone Option—Tone On Maximum Time
Specifies the maximum duration of the cyclic tone that will be recognised by the PBX. When the tone
sent from the telephone company is shorter than the value set here, the PBX recognises it as a tone-
on.
Note that this option can only be set when SVM Cyclic Tone Detection on this screen is set to
"Option".
To change SVM Cyclic Tone Option, follow the steps below:
1.
Change SVM Cyclic Tone Option.
2.
Set the status of the SVM2 card to "OUS", then "INS".
Default
600 ms
Value Range
20 × n (n=6–200) ms
Maintenance Console Location
2.11.5 [5-3-3] Voice Message—SVM
Programming Manual References
2.7.1 [1-1] Slot
Feature Manual References
1.16.5 SVM (Simplified Voice Message)
SVM Cyclic Tone Option—Tone Off Maximum Time
Specifies the maximum time that the PBX waits for a cyclic tone to be sent from the telephone
company before recognising it as a tone-off. When no tone is detected within the time set here, the
PBX recognises it as a tone-off.
Note that this option can only be set when SVM Cyclic Tone Detection on this screen is set to
"Option".
To change SVM Cyclic Tone Option, follow the steps below:
1.
Change SVM Cyclic Tone Option.
2.
Set the status of the SVM2 card to "OUS", then "INS".
Default
600 ms
Value Range
20 × n (n=6–200) ms
Maintenance Console Location
2.11.5 [5-3-3] Voice Message—SVM
Programming Manual References
2.7.1 [1-1] Slot
2.11 [5] Optional Device
PC Programming Manual 387