Cli Commands - Korenix JetNet 6710G Series User Manual

4.11.5 CLI Commands

Command Lines of the Warning configuration
Feature
Relay Output
Relay Output
DI State
Dry Output
Ping Failure
Port Link Failure
Power Failure
Super Ring Failure
Disable Relay
Display
Event Selection
Event Selection
Command Line
Switch(config)# relay 1
di DI state
dry dry output
ping ping failure
port port link failure
power power failure
ring super ring failure
Note: Select Relay 1 or 2 first, then select the event types.
Switch(config)# relay 1 di
<1-2> DI number
Switch(config)# relay 1 di 1
high high is abnormal
low low is abnormal
Switch(config)# relay 1 di 1 high
Switch(config)# relay 1 dry
<0-4294967295> turn on period in second
Switch(config)# relay 1 dry 5
<0-4294967295> turn off period in second
Switch(config)# relay 1 dry 5 5
Switch(config)# relay 1 ping 192.168.10.33
<cr>
reset reset a device
Switch(config)# relay 1 ping 192.168.10.33 reset
<1-65535> reset time
Switch(config)# relay 1 ping 192.168.10.33 reset 60
<0-65535> hold time to retry
Switch(config)# relay 1 ping 192.168.10.33 reset 60 60
Switch(config)# relay 1 port
PORTLIST port list
Switch(config)# relay 1 port fa1-5
Switch(config)# relay 1 power
<1-2> power id
Switch(config)# relay 1 power 1
Switch(config)# relay 1 power 2
Switch(config)# relay 1 ring
Switch(config)# no relay
<1-2> relay id
Switch(config)# no relay 1 (Relay_ID: 1 or 2)
<cr>
Switch# show relay 1
Relay Output Type : Port Link
Port : 1, 2, 3, 4,
Switch# show relay 2
Relay Output Type : Super Ring
Switch(config)# warning-event
coldstart Switch cold start event
121