Warning - Korenix JetNet 6710G Series User Manual

4.11 Warning

JetNet 6710G provides several types of Warning features for you to remote
monitor the status of end devices or the change of your network. The
features include Fault Relay, System Log and SMTP E-mail Alert.
Following commands are included in this group:
4.11.1 Fault Relay
4.11.2 Event Selection
4.11.3 Syslog Configuration
4.11.4 SMTP Configuration
4.11.5 CLI Commands
4.11.1 Fault Relay
JetNet 6710G provides 1 digital output, also known as Relay Output. The
relay contacts are energized (open) for normal operation and will close
under fault conditions. Fault conditions include, Ethernet port Link Failure,
Ping Failure and Super Ring Topology Change. You can configure these
settings in this Fault Relay Setting.
Relay 1: Click on checkbox of the Relay 1, then select the Event Type and
its parameters.
Event Type: DI State, Dry Output, Power Failure, Link Failure, Ping Failure
and Super Ring Failure. Each event type has its own parameters. You
should also configure them. Currently, each Relay can has one event type.
Event Type: Dry Output
On Period (Sec): Type the period time to turn on Relay Output. Available
range of a period is 0-4294967295 seconds.
Off Period (Sec): Type the period time to turn off Relay Output. Available
range of a period is 0-4294967295 seconds
.
113