Installing Boards On The Des-7210/7206; Simple Steps Of Board Installation; Connecting The External Interface Cables; Precautions - D-Link DES-7200 Hardware Installation Manual

DES-7200 Hardware Installation Guide
Figure 3-19 Schematic Diagram for the Components of the DES-7206
3.15 Installing Boards on the
DES-7210/7206
3.15.1

Simple Steps of Board Installation

1. Remove the appropriate component card or blank panel according to 3.14.
2. Replace it with the appropriate card and insert into the guide rail.
3. Push the card into position by using the ejector, and tighten the two captive screws on
the card with a straight screwdriver.
Warning
3.16 Connecting the External Interface
Cables
3.16.1

Precautions

Correctly distinguish single-mode and multi-mode fibers and interfaces.

Avoid bends of small radius at the connector.

3.16.2

Simple Connection Steps

1. Connect one end of the RJ45 connector for configuring Ethernet cables to the Ethernet
interface of t he de vice b oard and t he ot her e nd t o t he N MS or a c ontrol terminal; or
connect one end of the standard RJ45 serial port cable to the serial port of the device
board and the other end to the NMS or a control terminal.
2. Insert t he single-mode or m ulti-mode f iber into the a ppropriate interface ac cording t o
the identification on the panel of the line card. Distinguish the Rx/Tx end of the optical
fiber.
1. Do not hold the edge of the PCB or collide the components on the
PCB.
2. When you plug/unplug a PCB module, use the ejector, instead of
forcedly.
3-17