Mounting The Des-7210/7206 Into The Cabinet; Precautions; Simple Installation Steps; Installing The Fan Tray - D-Link DES-7200 Hardware Installation Manual

4. Install the tray and wiring layer on the rack according to the configuration of one rack
with one cabinet and one rack with multiple cabinets.
3.4 Mounting the DES-7210/7206 into
the Cabinet
3.4.1

Precautions

Before the DES-7210/7206 is mounted into the cabinet, first verify that the front and back
brackets of the cabinet are at the right locations. If the bracket is in the too front, the front
panel of the equipment may be too close to the front door, so that the front door cannot be
closed when n etwork c ables and p igtail f ibers are c onnected. U sually, you should ensure
that the spacing of at least 10mm is reserved between the front panel of the equipment and
that of the cabinet after installation.
Verify the following before installation:
The c abinet h as be en f astened pr operly and v arious modules in t he f rame h ave be en
installed. There should be no obstacles for installation in the frame and in the surrounding.
The equipment to be installed is ready, and has been moved to a place of easy handling and
close to the frame.
3.4.2

Simple Installation Steps

1. Levelly lift the DES-7210/7206 by two persons on both sides, and slowly move it to the
front of the frame.
2. Levelly lift the DES-7210/7206 to a position slightly higher than the tray or the slide rail
of t he c abinet, p ut t he eq uipment on to the t ray or t he s lide r ail, an d push i t i nto t he
cabinet.
3. Fasten the DES-7210/7206 onto the cabinet with screws. There are fastening notches
on bo th t he l eft and r ight of t he f ront pane l o n t he e quipment f rame. U se s crews t o
fasten t hem t o t he f astening bracket of t he c abinet. A fter f astened, t he equipment
should be stable and still in the cabinet.
3.5

Installing the Fan Tray

The DES-7210/7206 provides a ventilation system, 7210-FAN for DES-7210, and 7206-FAN
for DES-7206. Install the fan tray by performing the following steps:
1. Remove t he blank pane l o f the fan tray by loosing the captive s crews with a s traight
screwdriver and the cross screws with a cross screwdriver.
2. Push the fan into the cabinet along the guide rail.
3. Tighten the captive screws with a straight screwdriver. Figure 3-2 and Figure 3-3 show
the installed fan tray
3-4
DES-7200 Hardware Installation Guide