Table of Contents
Advertisement
DES-7200 Series Quick Installation Guide
Warning
Installing Boards on the DES-7210/7206
1.
Remove the appropriate component card or blank panel according to 3.14.
2.
Replace it with the appropriate card and insert into the guide rail.
3.
Push the card into position by using the ejector, and tighten the two captive screws on
the card with a straight screwdriver.
Warning
Installation Check
Verify if the external power supply matches the distribution panel of the cabinet.
After the equipment is installed, check if the front/back cabinet doors can be closed.
Verify that the cabinet has been fastened completely, and does not move or tilt.
Verify that the equipment has been installed in the cabinet, and all the cables have
been fastened to the cabinet.
Verify that the optical fibers and twisted pairs match the interfaces.
Verify that the cables have been bound properly.
Verify that the power cables are in good contact and comply with the safety
requirements.
Verify that the power module has been fastened onto the equipment with the two
screws on the panel.
Turn on the power switch and verify that the power module can work normally.
1.
Always wear an anti-static wrist strap before plugging/unplugging a
board.
2.
Do not hold the edge of the PCB or collide the components on the
PCB.
Components of DES-7210 and DES-7206
1.
Do not hold the edge of the PCB or collide the components on the
PCB.
2.
When you plug/unplug a PCB module, use the ejector, instead of
forcedly.
15
Advertisement
Table of Contents
