Connecting The Cable Of The Management Module; Simple Connection Steps - D-Link DES-7200 Hardware Installation Manual

DES-7200 Hardware Installation Guide
Figure 3-17 Schematic Diagram for the Connection of the AC Power Cable
3.12.2 Precautions
Before c onnecting t he p ower s upply, you m ust v erify t hat the external p ower s upply

provided matches the power module installed of this equipment.
Before connecting the power cable, you must make sure that the switch of the power

module is at the OFF position.
The power cable with a standard 3-pin connector should be used for connection.

You must ensure that the power cables connected are in good contact.

3.12.3

Simple Connection Steps

1. Insert the plug of the power cable into the power module.
2. Connect the other end of the power cable to the corresponding socket or connector.
3.13 Connecting the Cable of the
Management Module
3.13.1 Simple Connection Steps
1. Connect the end of the Ethernet cable with the RJ45 connector to the Ethernet port of
the equipment management module (7210/7200-CM1), and the other end to the NM or
control terminal.
2. Connect t he e nd of t he standard D B9 s erial c able with t he RS-232 s erial p ort t o t he
RS-232 serial port of the equipment management module, and the other end to the NM
or control terminal.
Note
The DES-7210/7206 system must have at least one management module
to work normally.
3-15